Quick card

As promised here is a quick card made from more scraps of the kit.

Instructions

Cut a rectangle of PP slightly smaller than your card blank. Ink the edges and attach to the card.

Take some kraft CS and cut into 3 rectangles, exactly the same. Ink the edges. Trim 3 rectangles of PP slightly smaller than the kraft CS, ink the edges and attach to the kraft CS. Attach the rectangle to the card.

Take a scrap of PP, i used the large red spotty, and make a scalloped border. Attach over the rectangles, towards the bottom of the card.

Hand draw a journal card on kraft CS and attach towards the right hand side of the card, just above the scalloped border.

Take a length of fabric and tie it around the card, tieing a bow on the left hand side.

And now its time to embellish. I made a paper rose from the red PP and glued it on with a hot glue gun. Glue on the felt flower and a epoxy rose. Cut out a few leaves from one of the PP and mount on green PP from the kit. Attach behind the flowers with foam pads. Add a bird whimsy and finish with a little alphabet title and button.

And there you go, a quick and simple card that would be suitable for many occasions.

And that is me done as your guest DT for this kit. I have had a great time and I hope i have shown you a variety of projects that have inspired you to break into your kit and have a go. If i have, i would love to see your creations so drop a link into the comments section.

Thanks once again to Leo for the chance to play with her beautiful kits.

Sarah